The following sources were recommended by my Tutor for viewing while preparing assignment 4 Light.
1. The broader the light source, the softer the light. The narrower the source, the harder the light. A broad light source lessens shadows, reduces contrast, suppresses texture. A narrow light source does the opposite. This is because, with a broad source, light rays hit your subject from more directions, which tends to fill in shadows and give more even illumination to the scene.
Tip: Position a portrait subject near a large, bright window that does not receive direct sunlight. It makes for a no-cost softbox— no studio equipment necessary.
2. The closer the light source, the softer the light. The farther the source, the harder the light. This stands to reason: Move a light closer, and you make it bigger—that is, broader—in relation to your subject. Move it farther away, and you make it relatively smaller, and therefore more narrow.
Think about the sun, which is something like 109 times the diameter of the earth—pretty broad! But, at 93 million miles away, it takes up a very small portion of the sky and hence casts very hard light when falling directly on a subject.
Tip: When photographing people indoors by available light, move lamps closer to them or vice versa for more flattering light.
3. Diffusion scatters light, essentially making the light source broader and therefore softer. When clouds drift in front of the sun, shadows get less distinct. Add fog, and the shadows disappear. Clouds, overcast skies, and fog act as diffusion—something that scatters the light in many directions. On overcast or foggy days, the entire sky, in effect, becomes a single very broad light source—nature’s softbox.
Tip: Materials such as translucent plastic or white fabric can be used to diffuse a harsh light source. You can place a diffuser in front of an artificial light, such as a strobe. Or, if you’re in bright sun, use a light tent or white scrim to soften the light falling on your subject.
4. Bouncing light acts as diffusion.Aim a narrow light source at a broad, matte surface—such as a wall, ceiling, or matte refiector—and it not only reflects the light but also diffuses it by scattering it over a wider area.
Use a shiny reflector, though, and the light will stay fairly narrow on the bounce. The most extreme type of shiny refiector—a mirror—will keep the light focused pretty much as narrowly in the reflection.
Tip: Crumple a big piece of aluminum foil, spread in out again, and wrap it around a piece of cardboard, shiny side out. It makes a good reflector that’s not quite as soft in effect as a matte white surface—great for adding sparkly highlights.
5. The farther the light source, the more it falls off— gets dimmer on your subject. The rule says that light falls off as the square of the distance. That sounds complicated, but isn’t really. If you move a light twice as far from your subject, you end up with only one-quarter of the light on the subject.
In other words, light gets dim fast when you move it away— something to keep in mind if you’re moving your lights or your subject to change the quality of the light.
Also remember that bouncing light—even into a shiny reflector that keeps light directional— adds to the distance it travels.
Tip: Set your camera’s flash (pop-up or hot-shoe) to fill flash for outdoor portraits on harshly lit days. This will lighten shadows on your subject’s face but won’t affect the background exposure—it will fall off by then.
6. Light falloff can be used to vary the relationship between the light on your subject and your background. If you place a light close to your subject, the falloff from the subject to the background will be more pronounced. Move the light farther from your subject, and the background will be relatively brighter.
The same holds true for sidelighting: With a light close to the side of your subject, the falloff of light across the frame will be more pronounced than if the light is farther away.
Tip: If your subject is frontlit by windowlight, keep the person close to the window to make the room’s back wall fall off in darkness. If you want some illumination on the wall, though, move the person back closer to it and away from the window.
7. Frontlighting de-emphasizes texture; lighting from the side, above, or below emphasizes it. A portraitist may want to keep the light source close to the axis of the lens to suppress skin wrinkles, while a landscapist may want sidelighting to emphasize the texture of rocks, sand, and foliage. Generally, the greater the angle at which the light is positioned to the subject, the more texture is revealed.
Tip: To retain detail in your fluffy pet’s fur, position the light source somewhat to the side rather than straight on.
8. Shadows create volume. That’s how photographers describe three dimensionality, the sense of seeing an image as an object in space, not projected on a flat surface.
Again, lighting from the side, above, or below, by casting deeper and longer shadows, creates the sense of volume. Still-life, product, and landscape photographers use angular lighting for this reason.
Tip: Try “Hollywood lighting” for a dramatic portrait. Position a light high above and slightly to the side of your subject, angled down, but not so much that the shadow of the nose falls more than midway down the upper lip.
9. Backlight can be used as highly diffused lighting. Very few subjects are totally backlit, that is, in pure silhouette, with no light at all falling from the front. A person with his back to a bright window will have light reflected from an opposite wall falling on him. Someone standing outside with her back to bright sunlight will have light falling on her from the open sky in front of her. In either case, you’ll need to increase exposure to record the light falling on the subject—and this light will deemphasize facial texture and dimensionality.
Tip: For spark in a backlit portrait or silhouette, try compositions that include the light source. This can drive your meter crazy, though, so bracket your exposures.
10. Light has color, even when it looks “white.” This is called color temperature, and our eye/brain computer is very adept at adjusting our perception so that we hardly notice it. Digital sensors and film, though, may record color casts where our eyes didn’t see them.
The color of early morning and late afternoon sunlight is warm in tone, while open shade at midday can be quite bluish. Tungsten light bulbs cast very yellow light. And any surface that light bounces off can add its color.
With digital cameras, you can use the white-balance control to neutralize color casts or to emphasize them—for example, to add a warmer tone to a landscape or portrait. With slide film, you had to choose the right film for the light you’d be shooting in, or compensate with filters.
Tip: Landscapes shot on clear days can be very blue, especially in the shadows. Set your camera’s color balance to Cloudy, which acts as a warming filter for a more golden glow.
Winston Link. There is a great use of light in many of his images including night images. The light used behind the steam in locomotives.
Here you can find an array of Video Tutorials on Light. Here is what tips I have picked up from these.
Our first tutorial shows the use of exterior light. Recommendations to shoot either morning or afternoon and to use the directional light at this time. The background of green trees was distant from the subject so as to allow a nice soft background with a large aperture and still make it easy to photograph the subject. The light gives a nice hair light to the top and right and the model is placed slightly to the side facing left. The light is very flattering of the type for a young model. Then a large white reflector is placed to the left side adding more flattering light to the face. Finally to give a type of studio light a travel light strobe and softbox along with travel light and soft box were used at a 45 degree angle to give Rembrandt light.
Tutorial two shows James Patterson photographing a ballet dancer and an acrobatic performer. With the case of the dancer two large side lights are used so that no mater what she does she has light to fill her whole body. There is cloth been blown on both sides. The light falls off giving a sends of depth. With the acrobatic performer a back light was used and then kickers to show off her physique. The main light is side light giving again depth and shadow. A light form above with the soft grid acted as a fill light and then several kickers. The soft grid gives a more directional light.
Lighting it up in Austin with Robert Seale.
This is quite an in depth tutorial with a set up of an array of equipment. There are a few key tips I picked up. When photographing a person outdoors try creating a shade from above and have it that they are lit from behind by the sun so that they appear as a silhouette. Therefore you are in control of what light you use to light up your subject. By doing this you can also decide how you want the sky to look dark or bright by changing your shutter speed as you would with a background light do you want sky blue or white sky. This rock star is wearing a black dress and she has been lit from behind with two rim lights about 15ft away each. A beauty dish is then used to light up her face it is at a slight angle just above her head. Too high and you would get racoon eyes and unflattering shadows. The rim light is usually +1 to 1.5 plus exposure to the Key light. In this case as she has white skin and white hair it is .5+ exposure. Usually key rim et are just out of shot. If they are too far away you are creating hard light and would need larger strobes.
Zack Arias shows us how to use a strobe/flash one light on a stand outdoors to great effect.
Drew Gardner Photography.
I can only look at this style of light use and be in awe and very confused. I can see some of the techniques which I have been studying such as back light, diffusion, shadows been used for depth and more features on the face. The subjects photographed seem to pop out of the page while the backgrounds are all very clear and very much part of the image. Light filtering through trees is often used with a combination of studio light. I will comeback to this artist again and agin until I have a more comprehensive understanding of this artists use of light.
His lighting set up is often very complex look at the group portrait how many different people and focuses there are with an array of lights to highlight each person or detail. Take also in consideration if you are photographing a crew for a Television show. A young woman you want to show in a flattering light however an older male actor will not want to be portrayed as if they have no wrinkles with the same light as a 20 year old actress. So the light used on both will be very different. All of these things must be considered when taking pictures.
I am trying to research as well as possible light use and my next step is to practice to set up my own home made studio and to play and learn to the point where I feel I can put together the final presentation of my assignment 4.